What common problems do hydraulic hoop bending machines encounter when used correctly?

Mar 18,2023

Hydraulic hoop bending machine is an automatic metal processing equipment that uses a hydraulic system. Its high efficiency and accurate operation are its great advantages. The following are several common problems encountered when the hydraulic hoop bending machine is used correctly:

1. Lead to deformation: During press processing, if the pressure is too large or too small, it may cause deformation of the metal material. In order to prevent this situation, it is necessary to set the pressure value reasonably according to the characteristics and size of the metal material.

Hydraulic hoop bending machine protection

2. Inaccurate bending angle: Due to the difference in the quality of the bending molds used, the bending angle may also be inaccurate, which will affect the processing effect. It is necessary to select a good quality mold and calibrate the bending angle of the mold.

3. Frequent equipment failures: If the hydraulic hoop bending machine fails, workers must stop quickly, find out the cause of the failure, and repair it.

Hydraulic hoop bending machine is an efficient and precise metal processing equipment, but there are also situations such as improper operation and equipment failure. Proper use, timely inspection and maintenance can ensure long-term operation of the equipment and excellent processing results.

Keywords:

The rebar bender works weakly

None

The rebar bender works weakly

None

Related Case / Service

The rebar bender works weakly

Related Cases

The rebar bender works weakly

1. Step on the foot deeply, check whether the switch spool is pushed into place, and adjust the switch limit screw if it is not pushed in place. 2. Check whether the oil pump is oiled or the strength is insufficient 3. Check whether the oil seal is aging (for machines that have been used for more than two years.